#CETUS3D EXTRUDER SOFTWARE#

IMPORTANT: If the extruder is not homing towards the end switch.

NOTE: when using repetier-host please use ping-pong communication setting to ensure a valid ACK is received for each command.

#CETUS3D EXTRUDER SOFTWARE#

Using any GCODE capable software send 'G28 X' or 'G28 Y' to home your axis, this will move the extruder towards the end stop. Next time after you home the z axis if you send G1 Z0 F2000 will move your extruder to the print surface. The result will be your actual Z height and this will be your new gamma_max value.Ĭhange the config gamma_max value and restart the printer. When you have got the extruder to just touch your print bed, using the gamma_max value subtract the Z value you just entered. Move the z axis so that the extruder just about half way to the print surface using 'G1 Z100 F2000', then work your way down to the print surface by lowering the Z value. Send 'G90' to tell your printer to use absolute position. (WARNING: if the extruder is not moving towards the end switch switch off the printer immediately) The z position is now the value defined in your config file setting 'gamma_max'.

Using any GCODE capable software send 'G28 Z' to home your Z axis, this will move the extruder to the maximum height end stop. Download the correct config file from the download link above.

Cetus3d extruder